![]() Her mom suggested we pile on the bed slats so the bed rests on top, which was better but not great and did result in some loud clacking wake ups and cats going everywhere. I was pondering some sort of funky extender with just the puzzle bits, but I remembered I'm an idiot and that wouldn't get past the curves. The problems I have seen in this are : 1) There is no going back, the current rails are scrap or installation art, 2) I don't know if the curve will be a nice touch or in the way but I am pretty sure cutting higher would be too much and I'd just have broken puzzle knobs, 3) I don't know if it will be sturdy and sound enough for either end of this abominator of an adapter, and 4) I have no clue what the appropriate "new" piece would be right for the new end. Simply chop off the heads of the rails, just below the curve I would think, and have the iron worker weld on the appropriate connector for a modern frame. This was my nifty idea, which means it's either genius or the kind of bad idea I tend to fall for. But maybe someone can advise if this is the best idea and who I should lookup in the phonebook other than welder. I got more responses like 'Oh sure, I can give that a shot.' The last thing we want is to ruin our horribly short classic frame and crush our cat in a dangerous trip to the floor. None of the welders seemed more than casually confident, if that. There was concern for the integrity of the rails, in terms of both their antique status as well as their actual post-op performance. This was the suggestion at another site last year and it proved to be a good idea but hard to execute. So now that you've heard my problem and even gotten some neat pics of other people's bed frames, here is what I've come up with so far, and I'm hoping to get more intel here: Option 1: Our pegs are more tapered like the first two photos. Our frame isn't quite so frightening and industrial, but this is a good shot of a similar design with no bed. This one shows better the interlocking connector. I'm shocked I found some really good ones: The end of each rail (behind the curves) is a jigsaw puzzle looking tongue that fits into a corresponding groove/latch on the boards.Īs promised, here are some pictures. There are no screws or small parts that I've noticed. (For those that can't imagine what I'm getting at, I found pictures and will provide in a moment.) But since they are too short, they make a nice ledge for one end or the other of the mattress to lay atop and bend the springs, etc. I imagine this was, and maybe still is, a nicer design, keeping the bed from slipping around. ![]() The rails curve inward at each end rather than continue straight to meet the headboard and footboard. ![]() ![]() Just enough so that our last two beds never rested naturally in the rails, resulting in my girl trying to figure out daily if she's getting big or if I buy cheap mattresses (neither is anywhere near the truth). How stubborn you ask? Well the bed frame has three issues, but really only one and the other two are only a result of the first: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |